Hardware S412 Overview : ParagonVoIP Support

Front Panel

LED	Indication	Status	Description
POWER	Power status	On	The power is switched on.
POWER	Power status	Off	The power is switched off.
SYSTEM	System status	Blinking	The system is running properly.
SYSTEM	System status	Static/Off	The system goes wrong.
WAN	WAN status	Static	Linked normally.
		Blinking	In communication.
		Off	Off-line.
LAN	LAN status	Static	Linked normally.
		Blinking	In communication.
		Off	Off-line.
1-4 (Line status)	GSM/3G/4G	Red: static	The GSM/3G/4G Trunk is idle.
		Red: blinking slowly	No SIM card.
		Red: blinking rapidly	The GSM/3G/4G trunk is in use.
	BRI	Orange: blinking	The BRI line is disconnected.
	BRI	Orange: static	The BRI line is connected or in use.
	FXO	Red: static	The PSTN line is idle.
		Red: blinking slowly	No PSTN line is connected to the FXO port.
		Red: blinking rapidly	The PSTN line is busy.
1-12 (FXS port)	FXS	Green: static	The analog phone is idle.
1-12 (FXS port)	FXS	Green: blinking	The analog phone is busy.

Port	Description
RJ11 (Line port)	FXO port (red light): For the connection of PSTN lines or FXS ports of traditional PBX. BRI port (orange light): For the connection of ISDN BRI lines. Note: The sequence number of the ports corresponds to that of the Indicator lights in the front panel. (I.e. the LED lights in the front indicate the connection status of the corresponding ports at the back panel.)
RJ11 (FXS port)	FXS port (green light): For the connection of analog phones. Note: The sequence number of the ports corresponds to that of the Indicator lights in the front panel. (I.e. the LED lights in the front indicate the connection status of the corresponding ports at the back panel.)
WAN/LAN	Yeastar S412 provides two 10/100Mbps adaptive RJ45 Ethernet ports, and supports 3 Ethernet modes. The default mode is “Single”. Single: LAN port will be used for uplink connection. WAN port is disabled. Bridge: LAN port will be used for uplink connection. WAN port will be used as bridge for PC connection. Dual: Both LAN and WAN ports can be used for uplink connection.
TF Slot	Insert TF card to store auto recording files.
Reset Button	Press and hold for 10 seconds to restore the factory defaults.
Power Inlet	Connect the supplied power supply to the port.

On this page